共找到 150 條與 固有誤差 相關的標準，共 10 頁
Positional tolerances of bore axes for fasteners
Esistono molte formule per calcolare una differenza di colore a partire dalle coordinate del colore di un campione di riferimento e di uno di prova.
Coloured surfaces. Colorimetry. Calculation of colour differences.
Tolerance system for threaded fasteners
GENERAL TOLERANCES. PART 1: TOLERANCES FOR LINEAR AND ANGULAR DIMENSIONS WITHOUT INDIVIDUAL TOLERANCE INDICATIONS.
本標準規定了皮帶輸送機型連續累計自動衡器（以下簡稱“電子皮帶秤”）的術語和定義、產品型號、計量性能要求、能用技術要求、電子皮帶秤的要求、試驗方法、檢驗規則及標志、包裝、運輸和貯存，還規定了電子皮帶秤的型式評價的試驗程序（見附錄A）、型式評價報告格式（見附錄B）。 本標準適用于利用重力原理，以連續的
Continuous totalizing automatic weighing instruments (electronic belt weighers)
Initial stops for dies
Generar tolerances part tolerances for linear and anyular dimension withuot individual to lerance indications .
Ground steel finished products. Round bars with h7 tolerance zone. Dimensions and tolerances
Set screw for initial stop for dies
Fasteners. Shouldered retaining screws.
1.1. Esta Norma estabelece os afastamentos permitidos nas dimens?es das pe?as usinadas, nas medidas onde n?o s?o indicadas toler?n cias
Brazilian regulations, for allowable deviations in a manner that does not specify tolerances,
規定了低壓有源電壓偏差補償裝置的術語和定義、功能要求、技術要求、試驗方法、檢驗規則、標志、包裝、運輸、貯存等內容
Low voltage active voltage deviation compensator
GENERAL TOLERANCES. PART 1: TOLERANCES FOR LINEAL AND ANGULAR DIMENSIONS WITHOUT INDIVIDUAL TOLERANCE INDICATIONS.
1. Scope 1.1 This Standard applies to ac and dc motors with inherent overheating protection designed to be used in accordance with the Rules
Motors with Inherent Overheating Protection
Fortpflanzung von Fehlergrenzen bei Messungen; Grundlagen
