共找到 150 條與 固有誤差 相關的標準，共 10 頁
Cross References: ISO 286-1:1988 ISO 286-2:1988 ISO 603-1 ISO 603-2 ISO 603-3 ISO 603-4 ISO 603-5 ISO 603-6 ISO 603-7 ISO 603-8 ISO
Bonded abrasive products. Limit deviations and run-out tolerances
Bonded abrasive products - Limit deviations and runout tolerances
GB/T3103 的本部分規定了公稱直徑為1 mm~150 mm、產品等級為A、C和F級、用于與螺栓、螺釘、螺柱和螺母組合連接用平墊圈的公差。本部分適用于非組合和組合平墊圈、標準和非標準平墊圈。本部分可用于非平墊圈。但不包括非平墊圈的所有公差。本部分不適用于錐形墊圈。產品等級F和A級墊圈用于產品等級
Tolerances for fasteners－Plain washers
Bonded abrasive products -- Limit deviations and run-out tolerances
Bonded abrasive products -- Limit deviations and run-out tolerances
Bonded abrasive products -- Limit deviations and run-out tolerances
What is ISO 13942 - Bonded abrasive products about?? ? ISO 13942 is the international standard that focuses on bonded
Bonded abrasive products. Limit deviations and run-out tolerances
本標準規定了螺紋公稱直徑為1-150MM的螺栓，螺釘和螺母用產品等級為A和C級沖壓平墊圈的公差。 推薦非標準墊圈也采用這些公差
Tolerances for fasteners-Plain washers
Tolerances of form and of position TOI.ERANCES OF POSITION FOR GLEARANCE HOLES FOR FASTENERS
Square wire steel pole with h11 deviation. Dimensions and deviations
General tolerances; tolerances for linear and angular dimensions without individual tolerance indications
Precision round steel rod with h9 deviation. Dimensions and deviations
本標準規定了電離輻射密度計的產品分類，技術要求，試驗方法，檢驗規則以及標志、包裝、運輸、貯存和隨行文件。 本標準適用于利用電離輻射測量物質平均密度的電離輻射密度計（以下簡稱密度計
Density gauges utilizing ionizing radiation
Tolerance system for threaded fasteners
GENERAL TOLERANCES-PART2:GEOMETRICAL TOLERANCES FOR FEATURES WITHOUT INDIVIDUAL TOLERANCE INDICATIONS
