共找到 150 條與 固有誤差 相關(guān)的標(biāo)準(zhǔn)，共 10 頁
Agricultural wheeled tractors - Front-mounted equipment - Part 2: Stationary equipment connection (adoption with deviations)
BILINGUAL * SAME AS ISO 2768-2 * W/D NO S/S This part of ISO 2768 simplifies drawing indications and specifies general
General tolerances – Part 2: Geometrical tolerances for features without individual tolerance indications
BILINGUAL * W/D S/S BY DS/EN ISO 22081 This part of ISO 2768 simplifies drawing indications and specifies general geometrical
General tolerances - Part 2: Geometrical tolerances for features without individual tolerance indications
Tolerance system for threaded fasteners
FASTENERS. TOLERANCES OF PLAIN WASHERS.
Terms relating to tolerance analysis
Hexagonal wire steel rod with h11 deviation. Dimensions and deviations
This part of ISO 2768 simplifies drawing indications and specifies general geometrical tolerances to control those features on the drawing which have
General tolerances - Part 2: Geometrical tolerances for features without individual tolerance indications
General tolerances — Part 2: Geometrical tolerances for features without individual tolerance indications
Hexagonal wire steel rod with h10 deviation. Dimensions and deviations
General tolerances — Part 2: Geometrical tolerances for features without individual tolerance indications
Aircraft fasteners. Manufacturing tolerances (rech.).
Przedmiotem normy s? tolerancje wymiarowe, nominalne naddatki na obróbk? skrawaniem oraz odchy?ki masy dla odlewów z metali nie?elaznych. Przedmiot
Non-ferrons metal castings Dimensional tolerances machining allowan- ces and weight deviations
ADOPTED_FROM:ISO 2768-1:1989 This part of ISO 2768 is intended to simplify drawing indications and it specifies general tolerances for linear
General tolerances — Part 1: Tolerances for linear and angular dimensions without individual tolerance indications
Positional tolerances of bore axes for fasteners
