共找到 150 條與 表面電阻 相關的標準，共 10 頁
The standard applies to measuring of the electrical surface resistance of conductive layers on components and test specimens. It specifies a procedure
Aerospace; measurement of electrical surface resistance of conductive layers
本標準規定了固體絕緣材料體積電阻率和表面電阻率的試驗方法。這些試驗方法包括對固體絕緣材料體積電阻和表面電阻的測定程序及體積電阻率和表面電阻率的計算方法。 體積電阻和表面電阻的試驗都受下列因素影響：施加電壓的大小和時間；電極的性質和尺寸；在試樣處理和測試過程中周圍大氣條件和試樣的溫度
Methods of test for volume resistivity and surface resistivity of solid insulating materials
These methods of test cover procedures for the determination of volume and surface resistance and calculations for the determination of volume
Methods of test for volume résistivity and surface resistivityof solid electrical insulating materials
Covers procedures for the determination of volume and surface resistance and for calculations of volume and surface resistivity. Both resistance tests
Methods of test for volume resistivity and surface resistivity of solid electrical insulating materials
Method of test for determination of plastics resistivity: Part 1: surface resistivity
Test methods of conveyer belts Determination of the surface resistance
本標準規定了固體絕緣材料體積電阻率和表面電阻率的試驗方法。這些試驗方法包括對固體絕緣材料體積電阻和表面電阻的測定程序及體積電阻率和表面電阻率的計算方法。 體積電阻和表面電阻的試驗都受到下列因素影響：施加電壓的大小和時間；電極的性質和尺寸；在試樣處理和測試過程中周圍大氣條件和試樣的
Methods of test for volume resistivity and surface resistivity of solid electrical insulating materials
本標準規定了絕緣漆漆膜體積電阻系數和表面電阻系數的測定方法。 本標準適用于絕緣漆漆膜絕緣電阻的測定。即對漆膜加上一定的直流電壓，用高阻計測定體積電阻RV和表面電阻RS，從而計算出漆膜的體積電阻系數ρv和表面電阻系數ρs.ρv以Ω·cm表示，ρs以Ω表示
Determination of volume resistivity and surface resistivity of insullac films
This CID covers the general requirements for an inductor. Inductors covered by this CID are intended for commercial/industrial applications
INDUCTOR, CHIP, POWER, LOW RESISTANCE, SURFACE MOUNT
本規范規定了表面安裝膜固定電阻網絡的-般要求。 本規范適用于無可靠性指標的和有可靠性指標的表面安裝膜固定電阻網絡。該電阻網絡包括氣密式密封的和非氣密式密封的
Resistor networks,fixed,film,surface mount,general specification for
Testing offlexible cords and cables. Measurements ofinsulation resistance, resistance of semi-conducting layers and surface resistance.
Inductor, Chip, Power, Low Resistance, Surface Mount
"This industry standard covers the general requirements for cermet or metal film type resistor networks@ primarily intended for incorporation
Leaded Surface Mount Resistor Networks Fixed Film
Industrial fabrics. Method for determination of surface specific electric resistance
本標準規定了在微波頻率下利用雙諧振器法測試超導體表面電阻的方法。測試目標是在諧振頻率下Rs隨溫度的變化。 本標準適用于表面電阻的測試范圍如下： ——頻率：8GHz＜f＜30GHz ——測試分辨率：0.01m?（f=10GHz） 測試報告給出在測試頻率下的表面電阻值，并且給出利用R
Measurements of surface resistance of high temperature superconductor thin films at microwave frequencies
